Vertiv SmartRow 2 - Safety Precautions and Measures; Important Notes; General Safety Information

To Next Page

To Previous Page

1 Safety Precautions and Measures

This section outlines the safety measures that should be taken into consideration for the SmartRow™ 2 infrastructure solution.

Ensure that you have reviewed all provided safety material before beginning any initial procedures, including the safety

measures detailed in the component manuals shipped with the equipment.

NOTE: The warning and cautionary notes throughout this document do not represent all safety points that should be

observed.

1.1 Important Notes

• Prior to beginning any operations, carefully review the contents of this manual, including all precautions,

compliance, and safety measures.

• Retain this manual for the entire service life of the product.

• Take note of any warning labels on the unit and its accompanying components.

• Only qualified personnel equipped with safety helmets, gloves, shoes, and glasses should move, install, or service

this equipment.

• The unit control must be used exclusively for its intended purpose. This product is tailored for industrial,

commercial, or other professional units (such as manufacturing, electrical, and instrumentation setups). It is not

meant for purposes related wholly to individuals without the necessary credentials. Strict adherence to the

norms and usage should be observed. The purpose of the design is well-defined; therefore, the manufacturers do

not assume any responsibility for any incorrect usage. The warranty is void in the case of improper use or

modifications.

• Provide professional maintenance personnel with a key to the product when needed.

1.2 General Safety Information

• Use tools with an insulation handle.

• Wear rubber gloves and safety shoes. For additional information about tool and accessory requirements, contact

Vertiv Technical Support.

• Avoid placing tools and metal objects on the battery's surface.

• Remove any metal objects from your persons, including watches, rings, and so on.

• Disconnect all power (including the product's breaker and all UPSpower) before beginning any operations on

the inner components of the product.

• During installation, charging operations are prohibited.

• Connection wires must meet the requirements. Contact Vertiv TechnicalSupport for more information.

• After an alarm sounds via the Vertiv™ Liebert® RDU501 Intelligent Monitoring Unit, it is critical to determine and

treat the cause quickly to avoid any further system damage.

• The presence of sharp edges, objects, and bare hooks poses a risk of injury; therefore, use caution when handling

any of the aforementioned items.

Vertiv™ SmartRow™ 2 Infrastructure Solution User Guide