Vertiv SmartRow 2 - Power Management (Mgmt)

Video device management
Note the following information about the Video Device Management page:
• The monitoring unit supports one Network Video Recorder (NVR) with a maximum of four IP cameras connected
to the NVR.
• The NVR and IP cameras must support both the onvif protocol and the RTSP protocol.
• Video management supports up to four channels of video access.
• Video management supports Google Chrome (recommended) and Microsoft Edge.
To navigate through the VideoDevice Management page:
1. From the Safe Mgmt - Video Surveillance tab, click the Video Device Management tab to connect the video
device.
2. Click the CLEAR  button to remove the existing video device information.
3. Enter the IP address of the video device in the Video device IP field.
NOTE: Ensure the IP address is available and every parameters is consistent with the device.
4. Enter the username and password in the Login User and Login Password field, respectively.
5. Click the Connection Test button to test whether the video device is successfully connected. A prompt message
appears if the connection was successful.
6. Click the SAVE  button.
To set video parameters or download the video:
Please visit the NVR/IPC for parameter setting.
Snapshot download
Note the following information about the Snapshot Download page:
• To capture or record the captured image by video device, you must first add the alarm linkage configuration. For
more information, see Alarm actions on page105 . When the configured alarm condition is triggered, the
captured image can be downloaded and deleted only through the Snapshot Download tab.
• The video triggered can be displayed as yellow manual video recording when it is played back.
• A maximum of five historical videos can be downloaded simultaneously.
• The system can save up to 50 photos.
• The captured video can be viewed through the Video Replay tab under the Video Surveillance menu.
To navigate through the Snapshot Download page:
1. From the Safe Mgmt - Video Surveillance tab, click the Snapshot Download tab to connect the video device.
2. Click on the photograph linkage to download the image.
3. Click the DELETE button on the right side to delete the photograph.
9.4 Power Management (Mgmt)
The Power Management page displays the current and historical record of energy consumption data in accordance with user-
defined rules to help users analyze the overall energy consumption of the equipment room. From the left-hand sidebar, click
the Power Mgmt icon to access the following three submenus: Current PUE, History PUE, and Calculation Setting.
9 Vertiv™ Liebert® RDU501
Intelligent Monitoring Unit Web User
Interface (UI)
Proprietary and Confidential ©2024 Vertiv Group Corp. 103
Vertiv™ SmartRow™ 2 Infrastructure Solution User Guide