5-24 OM EZ17 us 1.0 * ez17b510.fm
5
Hammer operation (option)
Hammer operation may only be performed with a shatter protection in the
defined work range.
– see chapter “ Shatter protection (option)” on page 4-15
The machine is not certified for demolition work according to EN 474-5.
Installing a Front Guard according to EN 474-5 (item 5.3.2.1) is not
possible.
Piercing/penetration hazard by objects from the front!
Machine operation involving piercing/penetrating objects from the front
can cause accidents wth serious injuries or death.
► During operation, all persons must stay clear of the work range of the
machine.
► Do not place the machine directly underneath the workplace during
demolition, otherwise parts can fall onto the machine or the building
can collapse.
► Only work in the work range.
► Machine operation is prohibited without a shatter protection.
Accident hazard due to tipping over of machine!
A tipping machine can cause serious injuries or death.
► Do not perform any demolition work under the machine. This could
cause the machine to tip over.
► The machine can lose its balance and tip over if a hammer or other
heavy attachment is used.
► Never turn, lower or set down the attachment abruptly.
► Do not extend or retract the boom abruptly.
► Do not use the impact force of the attachment to perform demolition
work. Broken or falling pieces can cause serious injuries.
► Machine travel is prohibited during hammer operation.
If several sizes of hydraulic hammers are available for the machine, the
following applies when using the Powertilt unit:
► Always use the smallest possible hydraulic hammer.
► Contact your dealer for information on the correct equipment.
To Next Page
Loading...
