OM EZ17 us 1.0 * ez17i400.fm 4-31
4
Start the engine
Damage to engine if it is started again immediately after stopping it.
► Wait at least 10 seconds before starting the engine again.
Damage to preheater if the preheating system is operated too long.
► Never preheat the engine more than 3 – 5 seconds.
1. Insert the starting key.
2. Turn the starting key to position 1.
3. All indicator lights illuminate for 2 seconds.
➥ Replace malfunctioning indicator lights immediately.
4. Turn and hold the starting key in position 2 until indicator light 30
(preheating) goes out.
➥ Charge indicator light 28 illuminates.
➥ Indicator light 29 for the engine oil pressure illuminates.
5. Turn and hold the starting key in position 3 until the engine starts.
➥ All indicator lights go out.
➥ If the engine does not start after 10 seconds:
➥ Interrupt the start procedure and repeat it after about 1 minute.
➥ If the engine still does not start after a few tries: contact a Wacker
Neuson service center for error analysis.
6. As soon as the engine runs:
7. Release the starting key as soon as the engine runs.
The engine will not start unless the control lever base is raised.
Warm-up phase of machine
After the engine has started, allow it to warm up at slightly increased idling
speed until it reaches its operating temperature of about 82 °C (180 °F)
(coolant).
Do not let the machine warm up at standstill.
During the warm-up phase, check for unusual noise, exhaust color, leaks,
malfunctions or damage.
In case of malfunctions, damage or leaks: park and secure the machine,
and find out the cause for the damage and have it repaired.
To Next Page
Loading...
