Wacker Neuson EZ17 - Machine Travel; Travel Position; Start and Stop Machine Travel; Operating Temperature Range

OM EZ17 us 1.0 * ez17b500.fm 5-3
5
5.4 Machine travel
Travel position
• Position the machine as shown.
• Position the boom at the center and raise it about 20 – 30 mm (8 – 12
in) off the ground.
Information
When traveling, raise the stabilizer blade sufficiently high off the ground.
Start and stop machine travel
Start machine travel
After starting the engine:
• Indicator lights 28 (charge indicator light) and 29 (engine oil pressure)
go out.
• Slowly actuate the travel lever.
➥ Machine starts traveling.
Information
The machine will not start machine travel unless the control lever base is
folded down.
Stopping
– see chapter “ Hydraulic brake” on page 5-2
Operating temperature range
The following operating conditions must be fulfilled in order to ensure
optimal output and a long service life of the machine.
Do not operate the machine at ambient temperatures above +45 °C (+104
°F) or below −15 °C (−5 °F).
The engine can overheat at ambient temperatures over +45 °C (+104 °F)
and cause the oil to age prematurely.
Rubber elements such as seals can become brittle at ambient
temperatures below −15 °C (−5 °F) and cause premature wear or damage
to the machine.
Contact a Wacker Neuson service centera Wacker Neuson service center
if the machine is operated outside the specified temperature range.
Fig. 77
20 – 30 mm
(8 – 12 in)