5-38 OM EZ17 us 1.0 * ez17b510.fm
5
Setting down
Crushing hazard when removing attachments!
If an attachment is not removed correctly, it can tip over and cause serious
injuries or death.
► Ensure that no one is in the danger zone.
► Lower the attachment to level and firm ground ensuring stability.
► Only remove the pins from the attachment if it is in a stabile position.
► Lower the attachment to the ground without too much pressure,
otherwise the resistance when removing the pins is too high.
Re-equipping the attachments is described below for a bucket.
If you are fitting or removing attachments with their own hydraulic
functions – offset bucket, for example – you must follow the special
information given in the Operator’s Manual of the attachment.
The hydraulic system of the machine is still pressurized even when the
engine is not running. Due to the residual pressure, the hydraulic quick
couplers can be removed but not installed back on again.
► Release the pressure.
To Next Page
Loading...
Need help?
General
