Wacker Neuson EZ17 - Setting down an Attachment

5-34 OM EZ17 us 1.0 * ez17b510.fm
5
➥ The check pin K (red) must be fully retracted.
Setting down an attachment
WARNING
Crushing hazard when removing attachments!
If an attachment is not removed correctly, it can tip over and cause serious
injuries or death.
► Ensure that no one is in the danger zone.
► Lower the attachment to level and firm ground ensuring stability.
1. Lower the attachment to about 5 – 10 cm (2 – 4 in) above the ground.
2. Actuate switch 40.
➥ The buzzer sounds.
3. Press and hold foot-operated pushbutton switch 4.
4. Pull and hold stabilizer-blade lever 10 as far as it will go.
➥ The quickhitch opens and unhitches the attachment.
Fig. 125
K
Fig. 126
40
4
10
Fig. 127