OM EZ17 us 1.0 * ez17w700.fm 7-35
7
Adding coolant
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Loosen screw B.
3. Remove cover A.
4. Carefully unscrew filler cap C and release the pressure.
5. Open filler cap C.
6. Add coolant up to the middle of the sight glass (FULL).
7. Close filler cap C.
8. Start the engine and let it warm up for about 5 – 10 minutes.
9. Stop the engine.
10.Remove the starting key and carry it with you.
11.Let the engine cool down.
12.Check the coolant level again.
13.If necessary, add coolant and repeat the procedure until the coolant
level remains constant.
14.Close and lock the engine cover.
Dispose of used coolant through approved methods for recycling.
To Next Page
Loading...
Need help?
General
