OM EZ17 us 1.0 * ez17w700.fm 7-33
7
Adding engine oil
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Raise the seat.
3. Clean the area around the oil filler cap with a lint-free cloth.
4. Open filler cap B.
5. Raise oil dipstick A slightly to allow any trapped air to escape.
6. Add engine oil.
7. Wait about 5 minutes until all the oil has run into the oil sump.
8. Check the oil level.
9. Add oil if necessary and check the oil level again.
10.Close filler cap B.
11.Push oil dipstick A back in as far as possible.
12.Lock the seat.
Use a suitable container to collect engine/machine fluids as they flow out
and dispose of them in an environmentally friendly manner.
To Next Page
Loading...
