Watts AERCO Edge [ii] - Page 103

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 103 of 196
2. Choose the Unit Application for this unit: DHW, Other or SH.
Unit Application = DHW Unit Application = SH
Figure 6.2.6-1: Unit Application Configuration
3. Depending on the Application chosen above, one of five Operating Modes appears.
Choose the Operating Mode appropriate for the unit:
TABLE 6.1: Operating Modes
Available Operating Modes
Application
SH
DHW
Other
1 Constant Setpoint
✓
✓
✓
2 Remote Setpoint
✓
✓
✓
3 Direct Drive
✓
4 Combination
✓
5 Outdoor Reset
✓
4. Depending on the Application and Operating Mode chosen in Steps 2 and 3, a number of
additional parameters appear. The table below shows which parameters appear for each
combination of Application and numbered Operating Mode.
TABLE 6.2: Unit Application Configuration Parameters
Available Parameters
Unit Applications & Operating Modes (see table above)
SH
DHW
Other
1
2
3
4
5
1
2
1
2
1
Unit SH Operating Mode
✓
✓
✓
✓
✓
2
Unit DHW Operating Mode
✓
✓
3
Unit Other Operating Mode
✓
✓
4
Unit SH Setpoint
✓
5
Remote Signal
✓
✓
✓
7
Unit Address
✓
✓
✓
✓
✓
✓
✓
✓
✓
8
Unit Baud Rate
✓
✓
✓
✓
✓
✓
✓
✓
✓
9
Unit DHW Setpoint
✓
✓
10
Analog Input Source 1
✓
✓
10 a Name
1
✓
✓
11
Unit DHW Remote Signal
✓