Watts AERCO Edge [ii] User Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 39 of 196
• Enter the upper and lower limits of the DHW setpoint in the DHW Setpt Low
Limit and DHW Setpt Hi Limit fields.
• Pressing Next takes you to the Select BAS Mode screen; skip to Section 2.4:
Completing the Installation for instructions.
Figure 2.3.2.1.2-5: BST Manager – DHW: DHW Analog Input Screen
4. If you chose Network or BAS, the Select BAS Mode screen appears. Skip to Section 2.4:
Completing the Installation for instructions.
2.3.2.1.3 EZ Setup: BST Manager – Other Application
Complete these instructions only if you chose Other at the end of Section 2.3.2.
Figure 2.3.2.1.3-1: BST Manager – Other: Select Your Boiler Application
1. The Other Operating Mode screen appears. Choose the operating mode for the “other”
application, either Constant Setpoint or Remote Setpoint, then press Next to continue.
Figure 2.3.2.1.3-2: BST Manager – Other: Other Operating Mode Screen

Watts AERCO Edge [ii] Specifications

General

Brand	Watts
Model	AERCO Edge [ii]
Category	Controller
Language	English