Watts AERCO Edge [ii] - IP Network; Bas

Edge [ii] Controller Operation Manual
SECTION 4: DIAGNOSTICS
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 85 of 196
4.6.1 IP Network
The IP Network option is used to check the IP interface used by onAER or BAS.
1. Go to: Main Menu → Diagnostics → Comm & Network → IP Network.
Figure 4.6.1: Comm & Network: IP Network Screen
2. View the status of the available parameters.
4.6.2 BAS
If the unit is part of a Building Automation System (BAS), the BAS screen provides a read-only
display of various communication parameters. The screen that appears depends on the
communication protocol specified in the BAS parameter in Advanced Settings → Comm &
Network → BAS (see Section 6.4.1: BAS (Building Automation System))
1. Go to: Main Menu → Diagnostics → Comm & Network → BAS.
BAS = BACnet IP BAS = BACnet MSTP
Figure 4.6.2: Comm & Network: BAS Screen
2. View the status of the available parameters.