Watts AERCO Edge [ii] - Isolation Valve Status Display; SmartPlate Device Status

Edge [ii] Controller Operation Manual
SECTION 7 – UNIT STATUS
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 177 of 196
7.5 Isolation Valve Status
The Isolation Valve Status screen displays which isolation valves have been designated as
always open (see Section 6.3.4.4: Valve Configuration), even during plant standby conditions. It
also displays the value of the Min # Valves Open parameter, set in Section 6.3.4.4: Valve
Configuration.
Note, this screen shows the command that the BST Manager is sending the isolation valve. Any
failure on the valve will not be reflected on this screen.
.
Figure 7.5: Isolation Valve Status Screen
7.6 SmartPlate Status
If the cascade includes one or more SmartPlate units, the SmartPlate Status screen appears in
the Unit Status round-robin on the BST Manager unit only. SmartPlate communication must be
enabled for this screen to be displayed (see Main Menu → Advanced Setup → BST Cascade
→ SmartPlate Comm).
Figure 7.6: SmartPlate Status Screen (if connected)