Watts AERCO Edge [ii] User Manual

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 51 of 196
2.3.2.2.3 EZ Setup: BST Manager – Space Heating and Other Applications
Complete these instructions only if you chose both Space Heating and Other at the end of
Section 2.3.2.
Figure 2.3.2.2.3-1: BST Manager – SH & Other: Select Your Boiler Application
1. The SH Operating Mode screen appears. Choose the desired operating mode, then press
Next to continue.
Figure 2.3.2.2.3-2: BST Manager – SH & Other: SH Operating Mode
NOTES:
• If the outdoor air sensor is not connected, the OAT (Outdoor Air Temperature) parameter
is disabled.
• If the header sensor is not connected, the bottom of the screen will display HDR = --- °F.
For the header sensor to function without previous setup, the default for HDR sensor must
be sensor enabled and the source is Direct. For information on adjusting the defaults see
Section 6.3.1 Cascade Configuration.

Watts AERCO Edge [ii] Specifications

General

Brand	Watts
Model	AERCO Edge [ii]
Category	Controller
Language	English