Watts AERCO Edge [ii] - BST Application Configuration

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 124 of 196
3. If the unit is configured as a BST Manager, the following additional parameters appear:
• Min & Max Addresses: The address range of the units in the BST cascade.
(Range: 1 to 16)
• SSD Temp Format: Choose either Points or Degrees.
6.3.3 BST Application Configuration
The BST Cascade’s Application Configuration screen allows you to configure individual
operating parameters that will be transmitted to all BST Client units.
Some parameters below appear in EZ Setup (see Section 2). This screen allows you to modify
individual parameters, as needed.
NOTES:
• This screen is available only after BST Cascade functionality has been enabled (see the
Unit Mode parameter in Section 6.3.1: Cascade Configuration).
• If the unit is configured as a BST Manager, the parameters apply to this unit and will be
transmitted to all BST Client units. If the unit is configured as a BST Client, the parameters
configured on the BST Manager will take precedence.
• If BST Cascade functionality is enabled on a unit, the Unit → Application Configuration
screen in Section 6.2.6 (above) is disabled.
1. Go to: Main Menu → Advanced Setup → BST Cascade → Application Configuration.
APPLICATION = SH (Space Heating) APPLICATION = DHW
APPLICATION = OTHER APPLICATION = SH+DHW-1Vlv
Figure 6.3.3: BST Cascade: Application Configuration – Example 1
st
Screens