Watts AERCO Edge [ii] - Accessing Controller Settings; Unit Configuration Parameters

Edge [ii] Controller Operation Manual
SECTION 6 – ADVANCED SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 94 of 196
6.1 Access
The Enter Password screen allows you to log in to the system. As mentioned in Section 1.6,
there are multiple passwords, each granting a specific level of access.
Figure 6.1: Advanced Setup: Enter Password Screen
1. Go to: Main Menu → Advanced Setup → Access. The Enter Password screen appears.
2. The password for AERCO Trained Technicians is 159. Enter 159 or the password you have
been given, then press Save.
6.2 Unit
The Unit screen provides access to parameters specific to the single unit. Note, some
parameters were set at the factory prior to shipping and cannot be changed.
NOTE:
You can navigate from one Unit screen to the next in round-robin fashion using the Page Left
and Page Right icons on each screen.
1. Go to: Main Menu → Advanced Setup → Unit.
Figure 6.2: Advanced Setup: Unit Screen
NOTE:
The Application Configuration button is enabled only if Unit Mode (in the Advanced Setup
→ BST Cascade → Cascade Configuration) = Off.