Watts AERCO Edge [ii] - Slow Logging Settings and Graph

Edge [ii] Controller Operation Manual
SECTION 5: TRENDING
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 91 of 196
5.2 Slow Logging Settings and Graph
Complete the instructions below to select the parameters for the Slow Logging graph.
1. Go to: Main Menu → Trending → Slow Logging Settings.
Figure 5.2-1: Trending: Slow Logging Settings Screen
2. Press Parameters to Plot. The Select Plot Parameters screen opens, displaying the
parameters available in this graph. You can select up to 4 parameters. The selected item(s)
turn green.
Figure 5.2-2: Trending: Select Plot Parameters Screen – Slow Logging
3. To set the logging duration (X-Axis), press the Duration field on the Slow Logging
Settings screen (Figure 5.2-1, above) and then choose the duration.
Figure 5.2-3: Trending: Select Logging Duration Screen – Slow Logging