Watts AERCO Edge [ii] User Manual

Edge [ii] Controller Operation Manual
SECTION 1: INTRODUCTION
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 14 of 196
To make a selection in a user-selectable parameter, press on the field you want to change (the
word Select in the figure below); a list of options appears. When you select an option, the
original screen reappears with your selection displayed in the field.
Figure 1.9-4: List Controls
1.10 Aborting an Action
The abort action is available when a process has begun but may need to be terminated prior to
completion. This is initiated by pressing the Abort button, if available, or pressing the Home
button in the touchscreen’s upper-right corner.
The following occurs when a process is aborted:
1. A confirmation screen appears. Select Yes to abort the process. If no action is taken within
15 seconds, or if you select No, the abort is cancelled, and the process continues.
Figure 1.10: Abort Confirmation Screen
2. When an abort is successful, the process terminates, and you are returned to the original
screen. When an abort is performed on a screen that has multiple items, items that were
entered up to that point are saved.
3. If the process completes while the Abort confirmation screen is displayed, the Abort action is
nullified.

Watts AERCO Edge [ii] Specifications

General

Brand	Watts
Model	AERCO Edge [ii]
Category	Controller
Language	English