Watts AERCO Edge [ii] - Communication and Network Diagnostics

Edge [ii] Controller Operation Manual
SECTION 4: DIAGNOSTICS
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 84 of 196
• The gas assist solenoid opens.
• The igniter is sparked.
4. Monitor the valve position out, blower voltage and speed, spark current, flame strength, gas
pressure and line voltage.
5. When observations have completed, disable the Pre-Start Up Mode control.
4.5.2 Versions
The Version Information screens displays the current version of the Controller’s various
firmware components.
1. Go to: Main Menu → Diagnostics → System → Versions.
Figure 4.5.2: System: Versions Information Screen
2. View the status of the available parameters.
4.6 Comm & Network
The Comm & Network screen provides access to screens that can be used to verify IP, onAER
and BAS communication, and check the status of communication with smart devices and
available space on a USB device plugged into the side of the Controller.
1. Go to: Main Menu → Diagnostics → Comm & Network.
Figure 4.6: Diagnostics: Communications Screen