Watts AERCO Edge [ii] - Page 58

Edge [ii] Controller Operation Manual
SECTION 2: EZ SETUP
OMM-139_E • 8/25/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 58 of 196
1. Go to: Main Menu → EZ Setup and start any of the EZ Setup configuration routines
described above.
2. After the first few steps, when the Load Settings screen appears, press Yes.
Figure 2.4-1: EZ Setup: Load Settings Screen
3. The Settings File Select screen appears. Choose the location of the setup file:
• If the settings are on a USB device, choose USB.
• If the settings are in the Controller’s on-board memory, choose Onboard.
• If you want to restore the original factory settings, choose Factory Settings.
Figure 2.4-2: EZ Setup: Settings Source Select Screen
4. The Overwrite Calibration screen appears. Press Yes or No to proceed. Pressing Yes will
overwrite the unit’s existing combustion calibration setting, while pressing No will retain
those settings.
Figure 2.4-3: EZ Setup: Settings Upload Complete Screen