Wegener iPUMP 6400 - Record Program to File; Procedure for Recording a Program to File

Operation
46 800009-01 Rev. J www.wegener.com
3. To save your changes, click the Activate button.To discard any changes, click the Cancel
button.
4. Next, set the Mute options. Select
Mute or UnMute from the drop-down boxes for Video ,
Audio Left , and Audio Right .
5. To save your changes, click the
Activate button.To discard any changes, click the Cancel
button.
6. Next, set the Audio Setting options. Update the parameters by changing the numbers in the
Analog Attenuation (dB) and Boost Headroom (dB) text boxes or selecting a different
option from the
Routing drop-down box.
7. To save your changes, click the
Activate button.To discard any changes, click the Cancel
button.
8. If
your iPump 6400 has the optional decoders, repeat the steps above using the Edit
button for Decoder 2 or Decoder 3 .
Record
Program to
File
The iPump 6400 can record incoming programs to stored files for later playback. Up to three
separate programs may be recorded at one time.
Note:
Record and Play settings are volatile through power cycles. Except for the Loop
Forever playlist setting, these settings are lost when the iPump 6400 is restarted. If
Loop Forever is selected, then the playlist chosen to loop forever begins playing
when the
iPump 6400 returns to service after a reboot.
Procedure for Recording a Program to File
1. Check that RF input and audio and/or video output connections are set. The CARRIER light
should be a constant green. See
iPump 6400 front panel LED indicator descriptions on
page 22.
2. Click the
Rec/Play tab from the web browser.
LAN IP Multicast Plays the first audio content if more than one is detected in the LAN stream.
If selected, also set the UDP Port and Multicast Address.
Program
Plays user recorded programs. See
Record Program to File on page 46.
Setting Function