上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
96 / 131
5. Set layer technics.
See Layer Operations for details.
6.1 Interface Overview
Layer interface is shown as follows:
• ①: Layer selection area
It is used to do the following:
– To switch to the page of the target layer, click the layer name.
– To modify the layer name, double click the layer name.
– To show all layers, check Show All. Otherwise, the system only shows
layers in the current toolpath file.
• ②: Parameter setting page
It is used to switch between the following pages by clicking switch buttons:
– General Parameters page
See General Parameters for details.
To Next Page
Loading...
