上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
30 / 131
2. Select a tube type.
3. Set related dimension parameters.
For corner radius, you can set it 0.5mm larger than the original one, so as to avoid
affecting cutting arrises due to wrong dimension.
3.2 Level and Center a Tube
This operation is used to adjust a tube to horizontal state and find the center line of
certain tube face.
To level and center a tube, do the following:
• For a rectangular tube, rotate the rectangular tube to the wider face and click
in machine control area.
The system automatically does the following:
– Level all faces of the rectangular tube as follows:
To Next Page
Loading...
