上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
92 / 131
Result of exploding micro joint shows as follows:
5.14 Chop Objects
This operation is used to divide the selected closed objects into several parts, so as
to chop machining waste and make it fall off easily.
Before chopping an object, ensure the object meets the following requirements:
• It is a closed object.
• It has not been executed micro joint.
• It does not contain other objects in it.
To chop objects, do the following:
1. Select several objects.
2. Click Object → Special Technics → Chop. Chop dialog box pops up:
3. Select a chopping method and set related parameters.
To Next Page
Loading...
