上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
91 / 131
5.12.2 Manually Execute Micro Joint
To manually execute micro joint, do the following:
1. To open Micro Joint dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Object → Special Technics → Micro Joint.
2. In Manual area, set the length of the connection line.
3. Left click to select a micro joint position.
4. Optional: If the system is in Lambda 5E configuration, check High Speed
Micro Joint to execute micro joint without turning on the laser at the micro
joint positio. The cutting head keeps moving without slowing down.
If you need to exit micro joint, right click the mouse.
Result of manual micro joint shows as follows:
5.13 Explode Micro Joint
This operation is used to separate an object into several objects according to the
micro joint position after executing micro joint, so as to trim redundant parts during
drawing a complicated object.
To explode micro joint, do the following:
1. Select several objects.
2. Click Object → Special Technics → Explode Micro Joint.
To Next Page
Loading...
