WEIHONG NcEditor V12 - Lubricate Lead Screw and Guide Rail

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
112 / 131
– Focus offset: distance between the origin and the focus after returning
to the machine origin.
4. To control the machine tool, click the following buttons:
– + / -: adjust the position of focus at Jog speed.
– Locate: locate to the focus position at Locate speed.
– Home: W-axis returns to the machine origin.
– Stop: W-axis stops moving.
During machining, you can click and set focus parameters like Cut Focus,
Punch Focus and so on in Layer Setting dialog box to use the function. See Layer
Function for details.
8.2 Lubricate Lead Screw and Guide Rail
This operation is used to avoid rustiness and cool the machine tool, so as to reduce
the influence of machining accuracy due to overheat of the machine tool and extend
the machine tool lifespan.
To lubricate lead screw and guide rail, do the following:
1. Click System → System Parameters, check Manufacturer and enter the
password.
2. Find parameter Enable Lubricate under 3.1 Lube category and select a
lubrication method by modifying the value:
– 1: automatic lubrication
Used to automatically lubricate lead screw and guide rail during
machining according to the set parameters.
See Automatically Lubricate Lead Screw and Guide Rail for details.
– 2: manual lubrication
Used to lubricate lead screw and guide rail by manually controlling the
machine tool.
See Manually Lubricate Lead Screw and Guide Rail for details.
8.2.1 Automatically Lubricate Lead Screw and Guide Rail
To automatically lubricate lead screw and guide rail, set the following parameters
under 3.1 Lube category:
• Lubricate Len: the distance between lubrication happening.
• Lubricate Time: the duration of each lubrication.