上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
29 / 131
3 Quick Start (in Tube Cutting Configuration)
This section introduces the following operations for laser cutting in tube cutting
configuration:
1. Return to the machine origin
2. Set type and dimension of a tube
3. Level and center a tube
4. Load a toolpath or draw an object
5. Calibrate capacitance
6. Set the workpiece origin
7. Simulate machining
8. Execute machining
9. Optional: Return to the center
10. Optional: Set automatic centering
For details of return to the machine origin, calibrate capacitance, set the
workpiece origin, simulate machining and execute machining, please refer to
Quick Start (in Sheet Cutting Configuration).
3.1 Set Type and Dimension of a Tube
This operation is used to set the type and dimension of the machining tube
according to the actual situation.
To set type and dimension of a tube, do the following:
1. Click System → Tube Cutting Setting. Tube Cutting Setting dialog box pops
up:
To Next Page
Loading...
