上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
32 / 131
• Set technics and layers.
See Technics and Layer Function for details.
After executing the above operations, you can click File → Save in menu bar or in
drawing toolbar to save the toolpath, so as to execute machining.
The imported toolpath is saved as a NCE file under NceFiles folder on the desktop. If
there is no such folder, the system creates one automatically.
3.4 Return to the Center
This operation is used to control each axis of the machine tool to returning to the
central position of the tube. For a rectangular tube, each axis returns to the central
position of the first face.
Before returning to the center, ensure the following:
• The system is in idle status.
• The machine tool has returned to the central position of the tube once.
To return to the center, click in machine control area.
3.5 Set Automatic Centering
If the length of the tube is too long, the part between the front and rear clamps will
suffer from bending deflection. Thus, after cutting a length of the tube, centering
data before machining is no longer applicable. To fix the deflection and ensure
cutting accuracy, the system supports Auto Centering.
After cutting a certain length, the system will automatically do leveling or faces
centering and execute breakpoint resume after centering is done.
Before setting automatic centering, ensure the following:
• The shape of the tube is rectangular.
• The system is under velocity loop control mode.
To set automatic centering, do the following:
1. Click System → Tube Cutting Setting. Tube Cutting Setting dialog box pops
up.
2. To enable automatic centering, check Auto centering.
To Next Page
Loading...
