上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
22 / 131
With it checked, it is unnecessary to set the workpiece origin after
loading a toolpath file. You only need to click . The system sets the
selected berth point as the workpiece origin by default.
• Set the workpiece origin by mouse:
1. To open Set Origin dialog box, do one of the following:
• In drawing toolbar, click .
• In menu bar, click Mach → Set Origin.
2. Click Set by Mouse. The cursor turns into .
It is suggested to enable Catch Option function, so as to locate easily.
3. Left click to specify the workpiece origin.
If you need to exit specifying the workpiece origin, right click the mouse.
2.5 Find Edges
This operation is used to calculate the rotation angle between the current sheet and
the machine coordinate system, so as to rotate the workpiece coordinate system
(WCS) by corresponding angle and establish a new WCS.
To find edges, do the following:
1. To open Edge Finding dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Mach → Edge Finding.
2. Check Enable Edge Finding.
3. Select one of the following:
– Auto
Used to specify a new WCS by finding three points automatically
according to the set berth point.
See Automatically Find Edges for details.
– Manual
Used to specify a new workpiece coordinate system by finding three
points manually.
See Munually Find Edges for details.
To Next Page
Loading...
