上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
97 / 131
– Layer number page
You can set cutting and piercing technics for each layer.
See Layer Operations for details.
– Layer number-Three Segment Parameters page
If you select 3-Segment in Layer number page, this page appears.
See Set Technic Parameters for details.
– Layer number-Arris Parameters page
It is exclusive for tube cutting configuration. It shares the same layer
with Layer number page.
See Over-arris Parameters for details.
– ③: Unit setting bar
It is used to set unit according to the actual situation.
6.2 Layer Operations
Layer operations include the following:
• Set technic parameters.
• Adjust the power curve.
• Add technic remarks.
After setting layer technics, do one of the following to save the setting:
• Click Save. The layer technics are saved into the technic library for backup.
• Click Save As. The layer technics are saved as a LTP file.
If you need to use the saved layer technics, click Import to import a LTP file.
6.2.1 Set Technic Parameters
To set technic parameters, do the following:
1. Select a piercing method.
See Piercing Methods for details.
2. Set parameters in Technic Parameters and Special Technic areas.
See Layer Technic Parameters for details.
To Next Page
Loading...
