上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
111 / 131
8 Auxiliary Machining Operations
This section introduces the following auxiliary operations for machining:
• Control focus
• Lubricate lead screw and guide rail
• Enable automatic exhaust
• Set a mark point
• Set a fixed point
• Show power
• Use a camera
8.1 Control Focus
Since focus differs in materials, this operation is used to automatically adjust the
focus during machining, so as to confirm machining quality.
To control focus, do the following:
1. Click System → System Parameters and modify the value of manufacturer
parameter Enable focus control under 3.5 Focus Control category to YES.
2. Click System → Focus Control. Focus Control dialog box pops up:
3. Check Parameters and set the following parameters:
– Locate speed: speed during locating focus.
– Jog speed: jog speed to adjust focus with button +/-.
To Next Page
Loading...
