WEIHONG NcEditor V12 - 5 Technics; Set Fill or Unfill

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
68 / 131
5 Technics
This section introduces the following technics before machining with NcEditor V12
Laser Cutting CNC System:
• Set fill or unfill
• Set a lead line
• Change the machining direction
• Change the machining order
• Compensate kerf
• Execute instant setting
• Set scan cutting
• Add cooling points
• Add release angles
• Add chamfer
• Bridge objects
• Execute micro joint
• Explode micro joint
• Chop objects
• Execute ring cut
• Do clearing
5.1 Set Fill or Unfill
This operation is used to reserve a certain part of closed objects. For objects set as
Fill, the system reserves the inside. For objects set as Unfill, the system reserves the
outside.
To set fill/unfill, do the following:
1. Select the target closed objects.
2. Do one of the following:
– In menu bar, click Object → Unfill/Fill.
– In drawing window, right click and select Unfill/Fill.
3. Select a setting method:
– Fill/Unfill
Used to manually set the selected objects as fill/unfill.