上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
122 / 131
9.10 Register the Software
This operation is used to restrict the system usage time.
Before registering the software, ensure the machine tool is in idle or e-stop status.
To register the software, do the following:
1. Get a registration code.
2. Register the software with a registration code.
9.10.1 Get a Registration Code
Before getting a registration code, do the following:
1. To get an account, do one of the following:
– Contact local sales.
– Dial 400-882-9188.
2. Fill in Registration Information Confirmation Letter and send it to Weihong
Company after sealing it. Weihong Company will put the information on file.
To get a registration code, do the following:
1. Click Help → About NcEditor. About NcEditor dialog box pops up:
To Next Page
Loading...
