上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
120 / 131
9.8 Count Machining
This operation is used to calculate the total number of machining.
To count machining, do the following:
1. In report bar, click Count. Machining Count dialog box pops up:
2. Check Enable counting, and set planned count and actions after counting.
The system automatically counts machining as follows:
• If a toolpath file is machined without any interruption, the number of
machining adds 1.
• If machining interrupted, the number of machining adds 1 after executing
breakpoint resume and finishing machining.
• After a new file is imported or the file name is changed, the number of
machining turns to zero.
To Next Page
Loading...
