WEIHONG NcEditor V12 - Change the Machining Order

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
75 / 131
5.4 Change the Machining Order
After drawing several objects, the machining order is the drawing order by default.
This operation is used to change the default machining order.
If you need to show the machining order, do one of the following:
• In toolbar, click .
• In menu bar, click View → Show Order.
To change the machining order, do one of the following:
• Automatically change the machining order.
• Manually change the machining order.
• Specify the machining order for a single object.
• Change the machining order in a list.
5.4.1 Automatically Change the Machining Order
To automatically change the machining order, do the following:
1. Select the target objects.
2. To open Auto dialog box, do one of the following:
– In menu bar, click Object → Mach Order → Auto Set.
– In drawing window, right click and select Mach Order → Auto.
Auto dialog box pops up: