WEIHONG NcEditor V12 - Load a Toolpath or Draw an Object

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
18 / 131
– Set Directly
Set the current position as the machine origin.
With this way, you MUST ensure:
• The position is the same with the machine coordinate.
• The machine tool has never been turned off.
• E-stop has never occurred.
– X-axis/Y-axis/Z-axis/W-axis
Return a single axis to the machine origin.
For safety, it is suggested to firstly return Z-axis.
You can also click Mach → Go Home and select a method to return to the machine
origin.
After returning to the machine origin, sign appears before each axis in machine
control area.
2.2 Load a Toolpath or Draw an Object
This operation is used to load a toolpath or draw an object for machining in sheet
cutting configuration.
To load a toolpath or draw an object, do the following:
• To load a toolpath, do one of the following:
– Drag the target toolpath onto icon or into drawing window.
– In tool bar, click / to open/import the target toolpath.
– In menu bar, click File and select one of the following:
• Open
Open a NCE file.
If a toolpath already exists in drawing window, the opened
toolpath replaces the original one.
• Import
Import a G/NC/DXF/DWG/PLT/ENG file.
If a toolpath already exists in drawing window, the imported
toolpath replaces the original one.