WEIHONG NcEditor V12 - Layer Technic Parameters

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
103 / 131
Generally, default values of machining parameters of cutting film like power and
cutting height are different from actual machining parameters. You need to set them
according to actual situation. You can set proper cutting film parameters in Cut Film
layer.
Outside Cut Height
The distance between the cutting head and the material surface during leading in
from outside material.
After setting the height, click Set Outside Height to confirm.
6.5 Layer Technic Parameters
Layer technic parameters include the following:
• Cutting parameters
• Piercing parameters
• Delay parameters
• Uplifting parameters
• Special technic parameters
• Over-arris parameters
6.5.1 Cutting Parameters
Cut Speed
The cutting speed when feedrate override is 100%.
Peak Power
The laser intensity during cutting when the laser device is adjusted via the analog
quantity.
Cut Frequency
The carrier frequency of PWM modulate signals during cutting, namely the light
output times in one second.
The larger the value is, the longer light output time is.
Duty Cycle
In per unit pulse cycle, the ratio of light output time to the unit pulse cycle time.
You can set it bt adjusting the laser device via PWM to set duty cycle during cutting
setting.
Cut Pressure
The auxiliary gas pressure during cutting.
It should be used together with proportional valve or multi-valve.
Cut Gas
The type of auxiliary gas used during cutting.