上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
105 / 131
Note: In Layer number-Three Segment Parameters page, Pierce in names of all parameters is omitted.
6.5.3 Delay Parameters
Pre-laser Off Delay
The delay time before the laser is turned off.
Pre-laser On Delay
The delay time before the laser is turned on.
Post-laser On Delay
After the laser is turned on, the system lasts the set time before the next step.
6.5.4 Uplifting Parameters
Lifting Height
The uplifting distance of the cutting head after cutting each object.
Pre-pierce Lift H
The uplifting distance of the cutting head after piercing each hole during
preliminary piercing.
6.5.5 Special Technic Parameters
Neglect
Not machine all the objects in the current layer.
Not Close Gas
Not close port Blow during cutting all the objects of the current layer.
Low-speed Start up
Used to confirm the cutting quality during cutting a thick plate.
With it enabled, the system cuts a start distance long aperture at start speed, so that
the gas can be blown into the aperture. Then cut at normal speed.
After enabling it, you need to enter the distance and speed to start.
Side Blow When Pierce
Used to open port Side Blow during piercing.
Side Blow When Mach
Used to open port Side Blow during machining.
Prepierce
Pre-piercing function is valid for all the objects of the current layer.
It is recommended to select method Increment Piercing or Segment Piercing.
Fixed Height Cut
Used to cut material at a fixed height.
You can get a fixed position or manually input the fixed position height to set it.
To Next Page
Loading...
