上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
62 / 131
To set vertical intersection, do one of the following:
• Set vertical intersection in drawing window:
1. Select the target objects.
2. Right click and select Intersecting Line.
After setting, the selected objects turn into white.
If you need to cancel setting of vertical intersection, select the objects, right
click and select Clear → Vertical Insect.
• Set vertical intersection in Tube Cutting Wizard dialog box:
1. To open Tube Cutting Wizard dialog box, do one of the following:
• In drawing toolbar, click .
• In menu bar, click Draw → Pipe Cutting Guide.
2. Click Intersecting to switch to pipe intersection interface and check Set
Vertical Insect.
3. Click Create Curve to generate toolpath.
The system generates and loads the cutting toolpath automatically.
4.4 Preprocessing Operations
This section introduces the following preliminary processing operations before
machining:
• Preprocess with one click
• Delete overlapping objects
• Delete self-overlapping lines
• Smooth polylines
• Trim self-intersecting polylines
• Turn text into polylines
• Turn polylines into circles
To Next Page
Loading...
