上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
61 / 131
The system provides the following weld compensation methods:
– Curve across arris compensation
– Straight arris overcut compensation
– Joint space compensation
Result of weld compensation methods shows as follows:
5. Click Create Curve to generate toolpath.
4.3.13 Set Vertical Intersection
Generally, outer cutting hole may be larger than inner cutting hole caused by
intersection cutting during pipe cutting. This operation is used to ensure the sizes of
outer and inner cutting holes are the same.
Before setting vertical intersection, ensure the following:
• The shape of tube is circular.
• The relationship between primary diameter and auxiliary diameter is as
follows:
Auxiliary diameter ≤ Primary diameter/2
To Next Page
Loading...
