上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
60 / 131
Set Tube Cutting
To set tube cutting, do the following (taking rectangular tube cutting as an
example):
1. To open Tube Cutting Wizard dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Draw → Pipe Cutting Guide.
2. To switch to rectangular tube cutting interface, click Rectangular-cutting.
3. Set the following parameters:
Angle
The angle between the cutting face and the central line of the tube.
Range: [5, 175]°
Y
Y-axis coordinate of the cutting position on the tube.
Notch Length
Reserved length between the start point and the end point when the tube is cut
for a round.
4. Optional: To enable weld compensation function, check Weld Compensation
and select a compensation method, so as to compensate shrink of weld joint
caused by welding.
To Next Page
Loading...
