上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
89 / 131
Result of bridging shows as follows:
5.12 Execute Micro Joint
This operation is used to connect the cutting part with surrounding workpiece
without falling down the workpiece. By doing this, you can avoid the problem that
the cutting part can neither fall from the gap of supporting rods nor be held by the
supporting rods during laser cutting, so that the part becomes warped and collides
with high-speed moving cutting head.
To execute micro joint, do one of the following:
• Automatically execute micro joint.
Execute micro joint according to count or space.
Used to automatically execute micro joint to selected objects according to the
set value.
• Manually execute micro joint.
Used to manually select micro joint position based on your requirement.
5.12.1 Automatically Execute Micro Joint
To automatically execute micro joint, do the following:
1. Select the target objects.
2. To open Micro Joint dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Object → Special Technics → Micro Joint.
To Next Page
Loading...
