上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
26 / 131
3. To confirm the new WCS by specifying three points A, B and C, do the following:
1. To specify points A and B, manually move the cutting head to the sheet
edge in X-axis positive direction and click Set A and Set B.
The system automatically connects points A and B to specify a new X-
axis.
X-axis coordinate of point A should be smaller than that of point B.
2. To specify point C, manually move the cutting head to the sheet edge in
Y-axis positive direction and click Set C.
The system automatically specifies a new Y-axis by taking a perpendicular line
to line AB through point C and confirms a new WCS.
If you need to specify the point again, click Reset ABC. The system restores the
current coordinate to the default value.
4. Click Calculate. Check the calculated locating result in Finding Result area.
If the rotation angle exceeds 15°, it indicates that the sheet is tilted and needs
placement and edge finding again.
2.6 Simulate Machining
This operation is used to see the moving form of the machine tool in advance, so as
to avoid machine tool damage due to programming mistakes in the toolpath file.
It includes the following:
• Cut frame
Used to confirm the machining range by running the system along the frame of
the toolpath file. During cutting frame, no actual machining occurs.
• Execute simulation
Used to check the toolpath in real time without running the machine tool. It
provides a fast but lifelike simulation machining environment. During
simulation, no actual machining occurs, and only the moving track of the
cutting head at high speed shows in drawing window.
• Execute dry run
Used to move the machine tool without turning on the laser and related ports of
laser. During dry run, no actual machining occurs.
To Next Page
Loading...
