WEIHONG NcEditor V12 - Execute Machining

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
27 / 131
2.6.1 Cut Frame
To cut frame, do one of the following:
• In machine control area, click .
• In menu bar, click Mach → Mach Control → Frame.
• On the keyboard, press F7.
2.6.2 Execute Simulation
Before executing simulation, ensure the following:
• The toolpath file has been saved.
• The system is in idle status.
To execute simulation, do one of the following:
• In machine control area, click .
• In menu bar, click Mach → Mach Control → Simulate.
• On the keyboard, press F8.
2.6.3 Execute Dry Run
To execute dry run, do one of the following:
• In machine control area, click .
• In menu bar, click Mach → Mach Control → Dry Run.
2.7 Execute Machining
This operation is used to automatically execute toolpath file until the end of block or
any intentional interruption.
Before executing machining, ensure the following:
• The toolpath file has been saved.
• No e-stop and alarms occur.
To execute machining, do one of the following:
• In machine control area, click .
• In menu bar, click Mach → Mach Control → Start.
• On the keyboard, press F9.