上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
44 / 131
4.2.6 Switch to Fill Mode
This operation is used to view closed objects that are set as fill. In this mode, fill
objects are filled in while other objects are shown in wireframe way.
To switch to fill mode, click View → Fill Mode.
If you need to switch to view all objects in wireframe way, click View → Wireframe
Mode. It is the default view mode.
4.3 Basic Editing Operations
4.3.1 Translate Objects
This operation is used to move the objects a certain distance.
In tube cutting configuration, translation character differs in the shape of the tube:
• Square tube cutting:
When an object is being translated, its center catches center line automatically.
Ensure that you move the object inside the tube in drawing window.
If you exceed the tube, the system cannot execute machining and prompts
“Convert to 3D toolpath failed!” in status bar.
• Circular tube cutting:
Since machining area for a circular tube has no limit, you can translate objects
in tube height area.
To translate objects, do the following:
1. Select the target objects.
2. Do one of the following:
– Press the left mouse button and drag the objects.
– Press ↑ / ↓ / ← / → on the keyboard.
– Do the following:
1. Click Object → Translate.
2. Left click on the drawing window, move the cursor to the target
position and click again.
To Next Page
Loading...
