上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
114 / 131
2. To move the cutting head to the target position, click X+ / X- / Y+ / Y- in
machine control area.
3. Select Mark Point n and click Set Mark. The current machine coordinate is set
as the mark point.
Range of n is from 1 to 8.
If you need to show all mark points in drawing window, click Show All.
If you need to automatically control the cutting head to return to the mark point,
select the target Mark Point n and click Go Mark.
8.5 Set a Fixed Point
This operation is used to control the cutting head to return to the fixed point after
machining.
To set a fixed point, do the following:
1. Click System → System Parameters. Parameter Setting dialog box pops up.
2. To set the machine coordinate of the fixed point, find parameters X machine
coordinate and Y machine coordinate under 4.2 Fixed Point category and
modify the values.
3. Click Mach → Back To Fixed Point. The cutting head automatically returns to
the fixed point.
8.6 Show Power
This operation is used to adjust the power curve through the displayed power in
feedback trace, so as to get a proper power curve and solve the problem of over-
burning in corners, achieving the ideal cutting effect.
To show power, do the following:
1. Click View → Track → Feedback Track.
2. After machining, click Mach → Show Power. The cursor turns into .
3. To show the power value of current position, move the cursor onto the
feedback trace.
To Next Page
Loading...
