上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
78 / 131
3. Check the object, and do one of the following to sort the machining order:
– Click Move Up/Move Down to move the object.
– Double click another object to move the checked object to the clicked
position.
5.5 Compensate Kerf
There exists deviation between the sizes of actual cutting part and theoretical part,
which is caused by the kerf in cutting. The deviation leads to a smaller size in outer
contour and a larger size in inner contour. This operation is used to compensate the
deviation and it is applicable to closed objects.
Kerf compensation includes the following:
• All shrink: shrink the cutting area.
• All expand: expand the cutting area.
• Unfill: shrink, fill: expand: shrink the cutting area of unfill parts while expand
the cutting area of fill parts.
Before compensating kerf, ensure the text has been turned into polylines. See Turn
Text into Polylines for details.
To compensate kerf, do the following:
1. Select the target closed objects.
2. To open Kerf Compensation dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Object → Kerf Compensation.
– In drawing window, right click and select Kerf Compensation.
Kerf Compensation dialog box pops up:
3. Select a compensation type and width.
To Next Page
Loading...
