上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
113 / 131
After setting parameters, the system turns on port Lubrication automatically for
lubrication time after running lubrication length.
8.2.2 Manually Lubricate Lead Screw and Guide Rail
To manually lubricate lead screw and guide rail, do the following:
1. Click Mach → Lubricate. Lubricate dialog box pops up:
2. Set the start point, end point and speed of lubrication and click Start.
The system starts to lubricate lead screw and guide rail.
8.3 Enable Automatic Exhaust
This operation is used to automatically exhaust smoke by fans installed below the
machine tool, so as to avoid a large amount of smoke during high-power laser
cutting.
To enable automatic exhaust, do the following:
1. Click System → System Parameters. Parameter Setting dialog box pops up.
2. Find parameter Enable auto exhaust and modify the value to YES.
8.4 Set a Mark Point
This operation is used to set the machine coordinate of the target position as that of
a mark point, so as to control the cutting head to return to the mark point as needed.
To set a mark point, do the following:
1. To open Mark Point dialog box, do one of the following:
– In drawing toolbar, click .
– In menu bar, click Mach → Mark Position.
Mark Point dialog box pops up:
To Next Page
Loading...
