上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
88 / 131
Result of manually adding chamfer without checking Create Chamfer By Fill Or
Unfill is as follows:
5.11 Bridge Objects
This operation is used to create a disconnected toolpath and connect objects with a
bridge, so as to reduce piercing counts without scattering the objects after cutting. It
is mostly used to connect strokes of characters.
Before bridging objects, ensure the following:
• Text has been turned into polylines.
• Group has been separated.
To bridge objects, do the following:
1. Click Object → Special Technics → Add Bridge. Bridge dialog box pops up:
2. Set the maximum space and width. The cursor turns into .
3. Left click to select the ends of the bridging parts.
If you need to exit bridging, right click or press Esc.
To Next Page
Loading...
