上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
31 / 131
– Center all faces of the rectangular tube as follows:
• For a circular tube, click in machine control area.
The system automatically centers the circular tube. The process is the same as
the above centering process of a rectangular tube.
3.3 Load a Toolpath or Draw an Object
This operation is used to load a toolpath or draw an object for machining in tube
cutting configuration.
Compared with sheet cutting configuration, operations in tube cutting configuration
differ in the following:
• Load a toolpath: the system supports to import/insert a IGS/IGES file.
• Draw an object: the system can generate an object through tube cutting wizard.
See Set Wizard (in Tube Cutting Configuration) for details.
To get details about operations in sheet cutting configuration, see Load a Toolpath
or Draw an Object.
After loading a toolpath or drawing an object, you can do the following:
• Edit and preliminarily process the object.
See Basic Editing Operations and Preprocessing
Operationsbasic_edit_tube_root_en.md for details.
To Next Page
Loading...
